AMADOS-II DB 531.3 05.00
Seed drill - Preparations for starting the operation
41
The display now shows the required
calibration rate [kg] which has been
automatically calculated for the calibration
area and the entered seed rate.
-
Weigh the seed collected (e.g. 4,5 kg). (Consider the
net weight of the bucket!).
-
Basing on the shown value, select the weight of the
collected calibration rate by the keys
or
.
e.g., basing on the value "5.0000" for 5 kg (for
nominal seed rate value 200 kg/ha), select the value
"4.5000" for a collected calibration rate of 4,5 kg on
the display.
Display of the collected, selected calibration rate
Error
km/h
1/min
4.5000
-
Press key
and thus store. By this value
“AMADOS-II” automatically calculates the new
setting lever position. The electric setting motor moves
the gearbox setting lever into this position.
If the fault message "ERROR 1" is shown,
the desired seed rate is not achieved. By
changing the pinions in the two range
gearbox this fault can possibly be remedied.
-
Check this new gearbox setting lever position by
a new calibration test. Repeat this procedure as
long as the collected and the required calibration rate
coincide.
Display after termination of the calibration test
Error
km/h
1/min
5.0000
-
If the collected and the wanted calibration rate
coincide, press key
and thus store this
value.
-
If the actual and the required calibration rate
coincide, wait at least 5 seconds and then press key
for storing this value.
For checking the calibration test repeat
this test after 2 - 3 seed box fillings. In case
of deviations of this calibration test, repeat
until the collected and the required
calibration amount coincide.
F
I
F
