Page 1-4
FPT-40 Fingerprint Terminal Installation & Operation Guide
x
Before connecting the device, please read and follow the installation
instructions. Failure to do so could cause equipment failure; Amano
is not responsible for any damages.
x
Please use the enclosed cable [either 6ft Ethernet, or 50 ft USB-to-
Serial cable to connect the FPT-40 Fingerprint terminal. If longer
serial cables for direct connect are required please consult Amano.
Understanding the FPT-40 Fingerprint Terminal Front Panel
The front panel of the FPT-40 Fingerprint terminal (see
Figure 1-1
)
contains the following controls:
x
LEDs:
During normal standby operation (power on), the
Green
LED
will flash once per second, and stay on momentarily when a
user successfully verifies. If a user fails to verify, the
Red LED
will
momentarily stay on.
Note:
If the fingerprint reader does not follow the standard LED
operational parameters, please consult support.
x
Speaker:
Provides audible voice verification of operations, i.e.,
"
Thank you
",
"Incorrect Password"
, "
Access Denied
", "
Invalid Id
",
"Please try again"
, etc. See Advanced Options on page 2-41 for
voice control.
x
LCD Screen:
Displays time, date, day, and operational information.
x
Fingerprint Sensor:
Enrolls (creates) template and verifies
fingerprint.
x
Keypad:
Used to input User ID, password, and perform menu
operation with the following keys:
ESC –
to perform exit, cancel, ignore when using the Menus.
MENU
– to access Menu structure.
OK
– to confirm and/or save selection.
-
power ON/OFF button.
T
or
S
- to scroll down or up for menu operations.
Note:
Press the Power ON/OFF
button to turn off the terminal.