FPT-40 Fingerprint Terminal Installation & Operation Guide
Page 2-1
Chapter 2: Fingerprint Operation
Getting Started
Start-up Welcome Screen (Power On)
Once the terminal is wall mounted and the communication connections
have been made, connect the terminal to AC power (see figure) and
power on to setup and enroll users.
DC/6V
Ethernet
Serial (DB9 to
USB CommStik)
AC Power
Back Plate
Retaining Screws
Figure 2-1 FPT-40 Fingerprint Terminal Bottom View
To start-up perform the following:
x
Ensure the AC Power Adapter is connected to the FPT-40 terminal
and plugged into an outlet. Press the power
button. The FPT-40
terminal, will display the splash screen, perform a diagnostic check,
and then display the Welcome screen (see figure).
Figure 2-2 Welcome Screen
Note:
The time and date can be set with the terminal keypad, or
downloaded to the terminal from the host PC utilizing the Time
Guardian software. The information such as date, time, daylight
saving time (DST), finger templates, and hours worked sent from
Time Guardian will have precedence over existing similar
information. That is to say Time Guardian will act as the master.