Alvarion BreezeACCESS EZ AU-EZ, System Manual

Page: 94 / 175

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS EZ AU-EZ 75 System Manual
4.2.6.2.2.4 Frequency
The Frequency parameter defines the transmit/receive frequency when DFS is not
enabled. If DFS is enabled, it sets the initial operational frequency upon starting
the DFS mechanism for the first time.
The range depends on the Sub-Band.
The default is the lowest frequency in the Sub-Band.
NOTE: (FCC 5.3 GHz units)
For full compliance with FCC regulations, if you wish to include one or more of
frequency channels 5270, 5275 and 5330 MHz in the set of frequencies to be
used, then the Transmit Power parameter in the AU should not be set to a value
above "20-Antenna Gain". If there is a need to use a higher value for this
parameter, these frequencies should not be used.
4.2.6.2.2.5 DFS Parameters
The DFS Parameters submenu is available only if DFS is supported by the current
Sub-Band.
Note that starting on SW version 5.2, the DFS feature is supported (although
disabled by default) for units using Country Codes 1060 and 1064 (Universal 5.4
GHz and Universal 5.8 GHz). When a unit using either one of these Country Codes
is upgraded from a SW version lower than 5.2 the feature will not be automatically
applicable. If the user wants to use the DFS feature he must re-apply the Country
Code values (see
Section 4.2.6.8.2 ). Note also that for these units, if the user
changes the working sub-band the DFS Option will be automatically be set to No.
For other Country Codes that support DFS when sub-band is changed the DFS
Option is forced to Yes.
The DFS Parameters submenu includes the following parameters:
4.2.6.2.2.5.1 DFS Required by Regulations
The DFS Required by Regulations option enables defining whether DFS should be
used for compliance with applicable local regulations. The options are Yes or No.
Selection of the No option will disable the radar detection and dynamic frequency
selection mechanism.
The default depends on the Country Code (No for Universal Country Codes in the
5.4 and 5.8 GHz bands, Yes for all other Country Codes that support DFS as
required by applicable regulations).
4.2.6.2.2.5.2 Frequency Subset Definition
The Frequency Subset Definition parameter defines the frequencies that will be
used in the DFS mechanism. The available frequencies according to the Sub-Band