Alvarion BreezeACCESS EZ AU-EZ, System Manual

Page: 89 / 175

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS EZ AU-EZ 70 System Manual

From Ethernet Only

From Both Ethernet and Wireless Link
The default is From Ethernet Only.
4.2.6.1.5 Show IP Parameters
The Show IP Parameters option displays the current values of the IP parameters,
including the
Run Time IP Address , Run Time Subnet Mask and Run Time
Default Gateway Address .
4.2.6.2 Air Interface Parameters
The Air Interface Parameters menu enables viewing the current Air Interface
parameters defined for the unit and configuring new values for each of the
relevant parameters.
4.2.6.2.1 ESSID
The ESSID (Extended Service Set ID) of the AU.
Valid values: A string of up to 31 printable ASCII characters.
The default value is ESSID1.
4.2.6.2.2 Frequency Definition
4.2.6.2.2.1 Sub-Bands and Frequency Selection
Each unit is delivered with one or more pre-configured Sub-Bands, according to
the country code. These sets of parameters include also the frequencies that can
be used and the bandwidth.
The parameters that determine the frequency to be used are set in the AU. If more
than one Sub-Band is available, the sub-band to be used can be selected. If only
one Sub-Band is supported, then the sub-band selection option is not available.
The SU should be configured with a minimal set of parameters to ensure that it
will be able to automatically detect and use the frequency/bandwidth used by the
AU, including possible changes in this frequency (Automatic Sub Band Select
feature).
To simplify the installation process the SU scans a definable frequencies subset
after power-up. The defined frequencies subsets may include frequencies from
more than one Sub-Band, enabling automatic detection of both frequency and
NOTE
The ESSID string is case sensitive.