Supervisor 5000 Installation Instructions
Page 32
For assistance: [email protected] +1 (909) 591-8431 PUD3667R1-6
Appendix A - Setting the Home Position
Fig. A1
Fig. A3
Fig. A2
Master Cabinet - Motor Controller Board
Barrier Home Position
Center Cabinet - Motor Controller Boards
1. Locate the motor controller board in the master or center
cabinet [Figure A1 or A2] respectively. The (D2) LED will be
blinking indicating normal operation mode.
2.
Press the 'Test Mode' button for two seconds. The (D2)
LED will be lit solid. You are now in test mode [Figure A1].
3.
Move the barrier a couple of inches in both directions and
then place it in the home position [Figure A3].
4. Press the 'Home' button to set.
5.
Press the 'Test Mode' button for two seconds to exit test
mode. The (D2) LED will return to blinking status indicating
normal operation mode.
6. Locate the slave motor controller board in the slave or
center cabinet.
7. Repeat Steps 1 through 5 for the slave barrier.
Motor
Controller
Board
Slave
Motor
Controller
Board
(Controls
barrier
on other
side of
cabinet)
Master
Motor
Controller
Board
Home
Position
Test
Mode
D1
D2
On center cabinets, the slave motor controller board controls
the slave barrier on the other side of the cabinet (the adjacent
lane).
NOTE
Activate
Summary of Contents for SU5000
Page 44: ......
