Alvarado SU5000, Installation Instructions Manual

Page: 18 / 44

Supervisor 5000 Installation Instructions
Page 18 For assistance: support@alvaradomfg.com +1 (909) 591-8431 PUD3667R1-6
I/O Control Board (13-0328 Rev. F) Terminal Descriptions
J2 Output Contacts J1 Input Contacts
Pin # Pin
Name Function
Description Contact
Type Function & Behavior
Description Pin # Pin
Name Function
Description Contact
Type Function & Behavior
Description
1 GNDX Ground N/A Common output signal
ground.
1 GND Ground N/A Common input signal ground.
2 ENTACX Authorized
Passage
Entry
MDC An output occurs when an
authorized entry passage is
completed.
2 ENTACC Good Card
Entry
MDC Opens the turnstile for one
authorized passage until
passage occurs or timeout.
3 ENTUCX Unauthorized
Passage
Entry
MDC An output occurs when an
unauthorized entry passage
is completed.
3 ENTREJ Bad Card
Entry
MDC Illuminates the entry side
RED User Status Icon for 2
seconds.
4 ENTALRX Unauthorized
Presence
Entry
MDC An output occurs when
there is entry into the lane
area from the entry direction
without authorization.
4 ENTPAS Free
Passage
Entry
SDC Sets the turnstile to Free
Passage mode in the entry
direction.
5 ENTCLSX N/A N/A Reserved 5 ENTCLS Close
Direction
Entry
SDC Sets the turnstile to No
Passage mode in the entry
direction.
6 EXTACX N/A N/A Reserved 6 ENTOVR Single
Override
Entry
MDC Opens the turnstile for one
authorized passage in the
entry direction independent
of the access control system.
(Typically used for button at
security desk.)
7 GNDX Ground N/A Common output signal
ground.
7 ENTSERVICE Visitor Mode SDC Places the turnstile in Free
Passage/Barrier Disabled
Mode in both the entry and
exit directions.
8 EXTACX Authorized
Passage Exit
MDC An output occurs when an
authorized exit passage is
completed.
8 GND Ground N/A Common input ground signal.
9 EXTUCX Unauthorized
Passage Exit
MDC An output occurs when an
unauthorized exit passage is
completed.
9 EXTACC Good Card
Exit
MDC Opens the turnstile for one
authorized passage until
passage occurs or timeout.
10 EXTALRX Unauthorized
Presence
Exit
MDC An output occurs when there
is entry into the lane area
from the exit direction without
authorization.
10 EXTREJ Bad Card
Exit
MDC Illuminates the exit direction
RED User Status Icon for 2
seconds.
11 EXTCLSX N/A N/A Reserved 11 EXTPAS Free
Passage
Exit
SDC Sets the turnstile to Free
Passage mode in the exit
direction.
12 EXTOVRX N/A N/A Reserved 12 EXTCLS Close
Direction
Exit
SDC Sets the turnstile to No
Passage mode in the exit
direction.
13 BLKSEN Blocked
Sensor
MDC An output occurs when
a sensor is blocked for a
defined length of time (default
15 seconds).
13 EXTOVR Single
Override
Exit
MDC Opens the turnstile for one
authorized passage in the
exit direction independent of
the access control system.
(Typically used for button at
security desk.)
14 SOUT-1 Free
Passage Exit
MDC An output occurs when there
is a activation in the exit
direction.
14 EXTSERVICE Horizontal
Arm
Breakaway
N/A Available on the SU3000 only.
15 GNDX N/A N/A Common output signal
ground.
15 GND Ground N/A Common input ground signal.
16 DHO Door Held
Open
MDC An output occurs when the
barriers remain open after
the allotted time to close
after passage (default 12
seconds).
16 N/O Normally
Open Mode
N/A Not available on the SU5000.
17 BREAKAWAY Barrier
Broken Away
MDC An output occurs when the
barrier holding force has
been exceeded and the
barriers give way.
17 BARDISABLE Barrier
Disable
Mode
N/A Not available on the SU5000.
18 SOUT-2 Crawl Sensor N/A Not available on the SU5000. 18 EMROVR Emergency
Override
SDC
(N.O. or
N.C.)
Opens the barriers toward
the unsecured side; barriers
remain open and turnstile is
inactive until SDC is removed,
or contact is reestablished
if N.C. jumper is enabled.
(Typically used for fire alarm
or life safety systems.)
19 SOUT-3 N/A N/A Reserved 19 SINPUT N/A N/A Reserved
20 GNDX Ground N/A Common output signal ground. 20 GND Ground N/A Common output signal ground.