Supervisor 5000 Installation Instructions
PUD3667R1-6
For assistance: [email protected] +1 (909) 591-8431
Page 13
Installation Instructions
Anchoring the Turnstile
1. Place the master cabinet and the slave cabinet in the determined location [see dimensions - Figure 4].
2. All cabinets must be level and square to eachother. This will ensure that the optical sensors are aligned, and that the barriers
will line up properly when installed. Use the following procedures to level the cabinets, and square each cabinet with respect to
the floor and other cabinets:
A.
Measure the distance from the inside wall of one cabinet
top channel to the inside wall of the other cabinet top
channel, on both the entry and exit side of the lane for a
consistent measurement [Figure 9A].
B.
Measure the diagonal distance from the end of one
cabinet to the end of the opposing cabinet, then
measure the opposing diagonal distance [Figure 9B]. If
these distances are equal, the cabinets are square.
C. Using a level, verify each cabinet is level [Figure 9C]. If
necessary, shim to bring the cabinets level.
Fig. 9A
Fig. 9C
Fig. 9B
NOTE
The lane 1 master cabinet is always the right-most cabinet in relation to the unsecured side.
Summary of Contents for SU5000
Page 44: ......
