Alutech CU-TR230, Installation And Operation Manual

Page: 101 / 138

CONTROL UNITS СU-TR230 / СU-TR400
99 99
SETTINGS
F3 — Record of four buttons of the remote control
with any control command selected in the setting
When entering the setting for all buttons of the remote control ( b1 – b4 ),
the default value of the control command is
00
. ( Table 4).
Table 6
1
Enter the setting menu ( Table 3) and select menu P2 .
Select the
F3
setting. After the desired setting appears, press
2
The display for ~ 2 s will indicate the first button b1 of the remote control,
which indicates a further selection of a control command for this remote
control button
3
Using or select the desired control command ( Table 4).
ATTENTION! If the button does not need to be assigned a control
command, then leave the value
00
4
Press to confirm the selected value (for example 01 );
after pressing the indicator will show the number with a dot
5
The display for ~ 2 s will indicate the second button b2 of the remote control,
which indicates a further selection of a control command for this remote
control button.
Then repeat steps 3 and 4 for the control buttons b2, b3, b4
6
After confirming of selected command of the button b4 with the
button the inscription rc will appear on the display, which means
waiting for the remote control signal
7 Press 3 times any button on the remote control
×3
8
The indicator will automatically show:
•
number without a dot , that is proposed to be assigned to an unrecorded
remote in the drive memory (using or the number can be
chosen from the available)
•
number with a dot
. The remote control has already been recorded
and after confirmation, a complete rerecording of the remote control
commands with the specified number will be performed!
9
Press to confirm the record; after pressing the indicator will show the
number with a dot (for example, number
01.
)
10
After ~ 2 s, an automatic transition to recording the next remote will occur
with a given combination of commands buttons b1-b4 of the remote (repeat
steps 7–9).
To exit the setting menu, press 3 times
×3