Alutech CU-TR230, Installation And Operation Manual

Page: 100 / 138

CONTROL UNITS СU-TR230 / СU-TR400
98 98
SETTINGS
6.2.1. REMOTE CONTROL RECORDING
Y
If you record a previously recorded remote control, the remote control button or buttons will
be rerecorded with new control commands!
no
— when recording remotes, the inscription means that the maximum number of remotes
is recorded.
F1 — Recording any button of the remote control with the control command STEP BY STEP
By default, the value 01 ( Table 4) is STEP-BY-STEP (ENTRY).
F2 — Recording three buttons of the remote control with the control commands :
OPEN (button
b1
), STOP (button
b2
), CLOSE (button
b3
). The default for
OPEN the value 02 ( Table 4) is OPEN (EXIT).
Table 5
1
Enter the setting menu ( Table 3) and select menu
P2
.
Select the setting
F1
or
F2
. After the inscription of desired setting appears,
press
2
The display will show the inscription
rc
, which means waiting for the remote
control signal
3
Press on the remote control 3 times (at least):
• for setting
F1 , the selected control button
• for setting
F2
any button
×3
4
The indicator will automatically show:
•
number without a dot
, that is proposed to be assigned to an unrecorded
remote in the drive memory (using or the number can be
chosen from the available)
• number with a dot . The remote control has already been recorded
and after confirmation, a complete rerecording of the remote control
commands with the specified number will be performed!
5
Press to confirm the record; after pressing there will be a number
with a dot on the indicator
6
After ~ 2 s, an automatic transition to recording the next remote will occur
(repeat steps 3 to 5).
Press the button 3 times to exit the setting menu
×3