14
my-netti.com
Model:
NettI 4U CE
Language:
English
Version:
2017-06
6. assemBling anD
aDJustment
for information about adapting the
wheelchair to the user, please see:
my-netti.com Knowledge centre.
6.1 UNPACkING
1. unpack all the parts, and check that
everything is there according to the
packing list.
2. mount the main wheels (chapter 6.2)
3. mount the front castors (chapter 6.3)
4. check and adjust the seat depth (chap.
6.6)
5. mount the back rest (chapter 6.5)
6. mount the arm support (chapter 6.11)
7. mount the seat cushion (chapter 6.8)
8. mount the leg supports (chapter 6.9)
9. mount the head support (chapter 6.10)
10. mount any accessories (chapter 5).
Weight of components (450 mm chair
width):
main wheels:
1,9 kg each
anti tip:
0,1 kg each
front castors:
0,8 kg each
leg support angle adj.:
2 kg each
seat cushion:
app. 1 kg
Head support a:
1 kg
Head support c:
0,9 kg
6.2 MAIN WHEEl
to mount the main wheel remove the
quick release bolt from the hub bushing,
lead it through the center of the main wheel
and into the hub bushing while pressing the
knob in center.
to check that the main wheel is
properly attached to the hub, remove
the finger from the central knob and
pull at the main wheel.
if the main wheel does not lock, do not
use the wheelchair but contact
your dealer.
sand and sea water (salt used for
gritting in the winter) can damage
the bearings of the main wheels and
front castors. clean the wheelchair
thoroughly after exposure
6.3 froNT CASTorS
are equipped with quick release axle.
To take off:
•
Press the release button under the front
fork.
To mount:
•
lead the quick release axle into the
bearing house. Pull the fork slightly to
ensure that the fork is fully locked.
6.4. SEAT HEIGHT ADjUSTMENT
the seat height at the rear depends on:
•
size of main wheel.
•
Position of main wheel.
•
using 24” main wheels in the upper hole,
the seat height is 465 mm from the floor
to the seating plate. using 24” main
wheels in the next lower position, the
height will measure 500 mm to the seating
plate.
