46
•
MN-35947
•
Rev 22
•
10/22
•
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
CT Classic™ Start-Up Procedures
How To Run a Cycle Test of the Appliance
Run the cycle test in combination cook mode
1. Touch the professional cooking mode icon
1
in the home
screen. The cooking screen displays.
2. Touch the icon for the combination cook mode
2
.
3. Touch the displayed temperature
4
.
The touchpad displays.
4. If necessary, use the number keys
8
to set the cooking
temperature to 350°F (177°C), then touch the check mark
icon
9
.
5. Touch the displayed time
5
. The touchpad screen
displays.
6. Use the number keys
8
to enter the cooking time
(00:15:00), then touch the check mark icon
9
.
7. Touch the start icon
6
. The start icon changes to a red
square (stop icon) and the appliance begins cooking.
8. Make sure that the appliance cycles correctly.
1. The appliance raises the cavity temperature to the set
temperature.
2. The appliance cycles off by itself when the set
temperature is reached.
3. The appliance idles until the cavity temperature
drops below the set temperature.
4. The appliance cycles back on by itself until the cavity
temperature again reaches the set temperature.
Allow the appliance to run through several cycles.
Cool down the appliance
1. Touch the stop icon
6
to stop the cooking process.
2. Touch the cool down icon
7
. The touchpad screen
displays.
3. Use the number keys
8
to set the cool down temperature
to 110°F (43°C).
4. Open the appliance door.
5. Touch the check mark icon
9
. The fan activates.
The cool down screen (not shown) displays the cavity
temperature at the top and the cool down temperature at
the bottom.
The fan turns off when the cavity temperature matches
the set cool down temperature.
Run the cycle test in convection cook mode
1. Touch the icon for the convection cook mode
3
.
2. Repeat the cycle test steps for convection cook mode.
3. Cool down the appliance when the cycle test is complete.
1
3
2
4
5
6
7
8
9
