MN-35947
•
Rev 22
•
10/22
•
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
•
21
Installation
SITE INSTALLATION
MINIMUM CLEARANCE REQUIREMENTS
LEFT
SIDE
0" (0mm)
MINIMUM
18"
(457mm)
RECOMMENDED SERVICE ACCESS
RIGHT
SIDE
0" (0mm) FROM NON-COMBUSTIBLE SURFACES
2"
(51mm)
FROM COMBUSTIBLE SURFACES
2"
(51mm)
FOR DOOR SWING
BACK
4" (102mm)
FOR PLUMBING
4-5/16" (109mm)
FOR OPTIONAL PLUMBING KIT
TOP
20"
(508mm)
FOR AIR MOVEMENT
BOTTOM
5-1/8" (457mm)
FOR LEGS AND UNOBSTRUCTED AIR INTAKE
NOTICE:
• A minimum distance of 18" (457mm) is strongly recommended for service access. If adequate service
clearance is not provided, it will be necessary to disconnect the gas, water, and drain to move the oven
with a forklift for service access. Service charges in connection with inadequate service access are not
covered under warranty.
• Do not install a stacked combination directly over a drain. Steam rising up out of the drain will
adversely aff ect operation, hamper cooling air circulation, and may damage electrical and electronic
components. Failure to comply will void the warranty. A single oven installed on a stand with solid
surface bottom shelf can be positioned over a drain since the solid surface will block the rising steam.
4" (102mm) for plumbing
4-5/16" (109mm) with optional plumbing kit
TOP VIEW
18" (457mm) f
or ser
vic
e ac
cess
0" (0mm) fr
om non-c
ombus
tible surf
ac
es
2" (51mm) fr
om c
ombus
tible surf
ac
es
2" (51mm) f
or door swing
POSITIONING ON SITE – COUNTERTOP MODELS
Place the oven on a stable, non-combustible level horizontal
surface. Use the adjustable feet to level the unit if the fl oor is
uneven.
It is strongly recommended that tabletop models be mounted on a
factory supplied stand or a stand that is stable, open, and level. The
adjustable oven legs should be extended beyond the depth of the
positioning ring to allow for leveling aft er the oven has been placed
on the stand.
Each of the legs on the stand and the
oven can be adjusted
2" (51mm) up or down.
Level the oven from front-to-back and
side-to-side by means of the adjustable
legs. Components within the oven
condenser tank are sensitive to pitch
and can be damaged. The tolerance to level is +/- 0.125"
(3.2mm). If this tolerance range is not achievable, the fl oor
must be repaired to obtain
level.
Adjustable
Leg
Adjustable
Leg
Positioning
Ring
4” (102mm)
6” (152mm)
Positioning
Rings
