67
-EN
01GB07IVA106E.fm
ALPINE IVA-D106E 68-12118Z27-A (EN)
< JAPANESE CAR >
To install using the vehicle’s genuine bracket.
•
Make sure to use the supplied flush head screw (M4
×
3) to install the
monitor.
If you use another screw to install the monitor, it may cause a
malfunction. However, only if you cannot install with the flush head
screws (M4
×
3), use the supplied screw (M4
×
6).
Ground Lead
IVA-D106E
Flush Head Screws (M4
×
3)
(Included)
Mounting Bracket
IVA-D106E
(Red)
(Yellow)
SPST SW (Optional)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
ACC
BATTERY
•
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
•
The diagram and the fuse amperage shown above are in the case when IVA-D106E is used individually.
•
If the switched power (ignition) lead of the IVA-D106E is connected directly to the positive (+) post of the vehicle
’
s battery, the IVA-D106E draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10 cm away from the car harness.
•
Keep the battery power leads as far away from other leads as possible.
•
Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•
If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
•
Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
01GB00IVAD106E.book Page 67 Tuesday, January 15, 2008 2:48 PM
