Figure 50 Date & Time Setting Interface
4.2.4.2 Additional Function Setting
A. If you use Backup box, please set as below:
C. If you use cascading function please set as following steps:
B. If external device will dispatch the system, please set as following steps:
Step 1
Click Enable to set yes.
Step 2
Set the priority of the load,
L1
＞
L2
＞
L3
Step 1
Please go to the function
menu, choose “Parallel” and press
enter.
Step 2
Please choose “Select” as
“Yes” and press enter.
Step 1
Please go to the function
menu, choose “ModBus” and press
enter.
Step 2
Please set Modbus enable as
yes.
Step 20
Click Language to set
language
Figure 51 Date & Time Setting Interface
Step 21
Make sure all the following
number is correct.
Note:
It is needed to set the following 3 parameters for manual mode:
IP Address: IP address;
Subnet Mask: Subnet mask;
Default Gateway: Default gateway;
Automatic display one parameter:
MAC Address: display MAC Address.
Step 3
Please choose “Phase” as L1
(master) and press enter.
Step 5
please repeat Step 1 to 4 to set the other device as L2 (slave) L3 (slave).
Step 4
Please choose “Mode” as
“Parallel mode” and press enter.
> > Information <
>
SN:
AL20020YYMMXXXX
> > > Language < < <
>
English
Deutsch
> > Backupbox < <
>
Enable
No
> > > Function < < <
>
Parallel
ModBus
> > > Function < < <
>
Parallel
ModBus
> > Parallel < <
>
Select
> > > ModBus < < <
>
Enable OFF
Mode Slave
> > Backupbox < <
>
L1 1 SOC 10
L1 2 SOC 10
L1 3 SOC 10
Yes
> > Parallel < <
>
Phase
L1
> > Parallel < <
>
Mode
Parallel Mode
EMS INTRODUCTION AND SET UP
EMS INTRODUCTION AND SET UP
42
43
