Camera interfaces
198
Manta Technical Manual V8.0.1
Control signals
The inputs and outputs of the camera can be configured by software. The different
modes are described in this section.
Input block diagram
I/O pin control
All input and output signals running over the camera I/O connector are controlled
by the I/O strobe commands. For more information, see the GigE Features
Reference.
Output signals
Output signals are configured by software. Any signal can be placed on any output.
The main output signals are described in the following table.
Figure 116: Input block diagram
Signal
Description
GPO
Configured to be a general purpose output, control of which is assigned to
SyncOutGpoLevels
.
AcquisitionTriggerReady
Active after the camera has been recognized by the host computer and is
ready to start acquisition.
Table 89: Output signals (sheet 1 of 2)
Polarity
selectable
via so
Ō
ware
Input state
Input signal
Optocoupler
LP
Į
lter
