Allied Vision BONITO, Technical Manual

Page: 8 / 83

Bonito Technical Manual V2.4.0
8
Introduction
continued from previous page
V2.2.0
(continued)
03.05.12
(continued)
• chapter Power supply (pin 1-4) on page 26
• Pin 6 changed from Reserve to Sync:
see chapter
Camera I/O connector pin assignment (15-pin
D-sub connector) on page 26
• chapter Synchronization output (pin 6) on page 27
• In chapter Exposure output (pin 12-13) on page 28: added
Note This output is not recommended for new system
designs. on page 29
• Added chapter Synchronization output (J) on page 45
• Updated the following chapter to new bit field order:
chapter
Exposure control mode (M) on page 46
• Range from N=0 (not N=1) in chapter Number of lines (N) on
page 60
• Added values 5 and 7 in chapter Camera Link output mode
setting (S) on page 61
• In chapter Reset to factory defaults (Z) on page 66:
Corrected E=000006BE (not 000006C1),
F=000006BF (not 000006C2)
Inserted J=01 and S=00
• Added new command reference description in chapter
Command reference on page 72
• Added hyperlink to Allied Vision website for DeviceConfig in
chapter
Serial I/O on page 23
• Changed AOI to ROI in the whole manual
V2.2.1 11 May 2012 • Some minor corrections
• Added 80 bit to Camera Link Full+
– chapter
Bonito CL-400B/C, Bonito CL-400B/C 200fps on
page 14
• Added 80 bit to clearly describe the 10-tap configuration of
the Camera Link standard:
– chapter
Camera Link interface (01-04 or CL1, CL2) on
page 30
– chapter Camera link connectors and 10-tap pin assign-
ment on page 30
to be continued on next page
Version Date Remarks
Table 1: Document history