Bonito Technical Manual
V2.4.0
62
Parameters and commands
•
For more information about pixel output timing, see chapter
Valid values:
Either
0
,
1
,
3
,
5
, or
7
Default
0
Related
Parameters
s
,
T
Examples
(see settings table below.
Setting
Function
S=0
•
Mode:
Single channel mode
•
Frame rate:
193 fps
•
Line length:
2320 pixels
•
The camera utilizes one Camera Link 80-bit channel in 10-
tap configuration. It allows only half of the maximum frame
rate but also produces less noise in the image because the
sensor clock frequency is reduced.
(To be continued on next page.)
S=0
(Continued from previous page.)
The preferred Camera Link connector pair for this mode is the left
channel O2 / O1, but the other pair (O4 / O3) also outputs all
pixel data. The CC signals and SerTC / SerTFG are handled sepa-
rately per channel. That means for example the trigger source
selection (
T
) and serial port configuration (
s
) might need
adjustments if O4 / O3 are used. The
Bonito CL-400B/C 200fps
provides only one channel at the connectors CL1/CL2.
S=1
•
Mode:
Dual channel mode (
not
for Bonito CL-400B/C
200fps)
•
Frame rate:
386 fps
•
Line length:
2 x 1160 = 2320 pixels
The image is split vertically into a left and a right half. Each half
has a horizontal size of 1160 pixels and is output separately via
its own Camera Link 80-bit channel. The left half travels via the
left Camera Link channel at the connectors O2 / O1 and the right
half travels via O4 /O3 respectively.
S=3
•
Mode:
Dual channel mode (
not
for Bonito CL-400B/C
200fps)
•
Frame rate:
386 fps
•
Line length:
2 x 1120 = 2240 pixels
This mode is the same as
S=1
, with the difference of a shortened
line length. For frame grabber compatibility reasons 40 pixel col-
umns at the left and right side of the full image are dropped so
that the line length of each image half is divisible by 16.
Table 23: Camera Link output settings.
