Allied Telesis AT-S80, User Manual

Page: 174 / 346

Chapter 14: Bandwidth Control
174 Section I: Using the Menus Interface
3. From the Advanced Switch Configuration Menu, type M to select Set
Ingress Mode .
The following prompt is displayed:
Set Bandwidth Control-> Enter port number>
4. Type a port number. Then press Enter.
The following prompt is displayed for port 12:
Enter Ingress Mode for port 12 (B/M) >
5. Type B to select broadcast or M to select multicast.
6. Type Q to select Quit to previous menu and save your changes.
Setting the
Ingress Limit
Rate
To set the ingress limit rate on the switch, perform the following procedure.
1. From the Main Menu, type B to select Basic Switch Configuration .
2. From the Basic Switch Configuration Menu, type B to select
Bandwidth Control .
The Advanced Switch Configuration Menu is shown in Figure 42 on
page 173.
3. Type L to select Set Limit Rate .
The following prompt is displayed:
Enter threshold level for all ports (L/M/H)>
4. Type L for a low threshold level, M for a medium threshold level, or H
for a high threshold level.
5. Type Q to select Quit to previous menu and save your changes.
Setting Ingress
Status
To enable or disable ingress status on a port, perform the following
procedure.
1. From the Main Menu, type B to select Basic Switch Configuration .
2. From the Basic Switch Configuration Menu, type B to select
Bandwidth Control .
The Advanced Switch Configuration Menu is shown in Figure 42 on
page 173.