Allied Telesis AT-S79, User Manual

Page: 47 / 210

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 47
Returning the AT-S79 Management Software to the Factory Default
Values
This procedure returns all AT-S79 management software parameters to
their default values and deletes all tagged and port-based VLANs on the
switch. The AT-S79 management software default values are listed in
Appendix A, ”AT-S79 Software Default Settings” on page 205.
Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
To return the AT-S79 management software to the default settings,
perform the following procedure:
1. From the Main Menu, type T to select Switch Tools .
The Switch Tools Configuration Menu is shown in Figure 9 on page 42.
2. From the Switch Tools Menu, type R to select System Reboot to start
the reboot.
The System Reboot menu is shown in Figure 10 on page 43.
3. Type O to select Set Reboot Option .
The following prompt is displayed:
Select reboot option (F/I/N)>
4. Type F or I to select one of the following:
F (Factory Default)
Resets all switch parameters to the factory default settings, including
IP address, subnet mask, and gateway address.
I (Reset to Defaults Except IP Address)
Resets all switch parameters to the factory default settings, but retains
the IP address, subnet mask, and gateway settings. If the DHCP client
is enabled, it remains enabled after this reset.
Note
Option N is described in “Rebooting the Switch” on page 42.