70143101
27
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
27. CYLINDER AND BEARING ASSEMBLY
STACKED TUMBLE DRYER
a. Unlock and remove upper lint drawer.
(For lower tumble dryer, both upper and lower
lint drawers need to be removed. Remove two
screws in upper lint compartment opening.)
.
c. Remove front panel. Refer to
.
d. Remove palnut, jamnut and washer from
e. Remove drive access cover at rear of tumble
.
f. Reach into cabinet and carefully apply
downward pressure on idler pulley. Slide belt
off motor pulley and then slowly release
pressure on idler pulley. Refer to
g. Pull cylinder out through front of cabinet.
h. Install cylinder guide tool on cylinder shaft
before reinstalling cylinder. Refer to
.
STAND ALONE TUMBLE DRYER
a. Unlock and remove lint panel. Refer to
.
b. Remove front panel. Refer to
.
c. Remove palnut, jamnut and washer from
cylinder shaft. Refer to
.
d. Remove drive access cover at rear of tumble
.
e. Supporting the motor, lift up and run belt off
f. Pull cylinder out through front of cabinet.
g. Install cylinder guide tool on cylinder shaft
before reinstalling cylinder. Refer to
To reduce the risk of injury, use care when
reaching into cabinet through belt service
door. The idler pulley could snap into place,
causing injury.
W230
CAUTION
Figure 17
T261SE1A
Palnut
Jamnut
Washer
