Alliance Laundry Systems AT0350SRG, Service Manual

Page: 20 / 60

18
70143101
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
16. FRONT PANEL
Refer to Figure 3 .
STACKED TUMBLE DRYER
a. Unlock and remove upper lint drawer. (For
lower tumble dryer, both upper and lower lint
drawers need to be removed.) Then remove two
screws in upper lint compartment opening.
b. Unlock controls and remove. Refer to
Paragraph 18 .
c. Remove two screws at the loading door hinge.
Refer to Figure 1 .
d. While supporting front panel, remove screws
holding front panel to cabinet, leaving one
screw on the top.
e. Pull bottom of panel away from tumble dryer
far enough to disconnect door switch wires.
NOTE: Refer to wiring diagram when rewiring
electronic control.
f. Remove remaining screw at top and remove
front panel.
Figure 3
ST AR
T
25
C
HIG
H TE
MP
ME D TE
MP
LO W TE
MP
NO HE
AT
1
2
3
SE LE CT TE
MP
IN
SE RT CO
IN
PU
SH ST AR
T
1
2
3
SE LE
CT TE MP
INS ER
T
CO
IN
PU
SH ST
AR T
ST AR
T
25
C
HIG
H TE MP
ME
D TE MP
LO
W TE MP
NO HEA
T
TMB1751S
FRONT
PANEL
PANEL
SCREWS
CONTROL
UPPER
LINT DRAWER
LOWER
LINT DRAWER
LOWER
DOOR SWITCH
CONTROL
UPPER
DOOR SWITCH