Alliance Laundry Systems AT0350SRG, Service Manual

Page: 47 / 60

70143101
45
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
STAND ALONE TUMBLE DRYER
Refer to Figure 37 .
a. Unlock and remove lint panel. Refer to
Paragraph 19 .
b. Remove front panel. Refer to Paragraph 16 .
c. Remove palnut, jamnut and washer from
trunnion shaft. Refer to Figure 17 .
d. Install cylinder guide tool on cylinder shaft.
Refer to Figure 20 .
e. Remove drive access cover at rear of tumble
dryer. Refer to Figure 31 .
f. Raise motor assembly and run belt off motor
pulley.
g. Pull cylinder out through front of cabinet. Refer
to Paragraph 27 .
NOTE: Before reassembling cylinder, clean interior
of cabinet, checking to make sure all tools have been
removed.
Figure 37
T163KE3B
Washer
Drive
Access
Cover
Idler
Pulley
Motor
Pulley
Belt
Cylinder
Tension
Sprin g
Motor
Assembly