Publication 2711P-UM001B-EN-P
2-12
Installation
6.
Insert all mounting levers (4 or 6) into the mounting slots on the
terminal (as shown below). Slide each lever until flat side of
lever touches the surface of the panel.
7.
When all levers are in place, slide each lever an additional notch
or two until you hear a click.
8.
Rotate each lever in direction indicated until lever is in final
latch position. Follow the latching sequence below to obtain
optimum terminal fit.
Use the table below as a guide to insure an adequate gasket seal
between terminal and panel.
Mounting Slots
Mounting Levers
Flat Side of Lever
Notch
6
1
Alignment Marks
Rotate lever until notch in
lever aligns with proper
alignment mark on terminal.
6 Levers
2
4
6
5
1
3
1
4
3
2
4 Levers
Lever Position
Panel Thickness Range
Typical Gauge
1
0.15 - 2.01 mm (0.060 - 0.079 in)
16
2
2.03 - 2.64 mm (0.08 - 0.104 in)
14
3
2.67 - 3.15 mm (0.105 - 0.124 in)
12
4
3.17 - 3.66 mm (0.125 - 0.144 in)
10
5
3.68 - 4.16 mm (0.145 - 0.164 in)
8/9
6
4.19 - 4.75 mm (0.165 - 0.187 in)
7
Terminal Markings
or Alignment
1
2
3
4
5
6
ATTENTION
!
Follow instructions above to provide a proper
seal and to prevent potential damage to the
terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to
the terminal or other equipment within the
enclosure because of improper installation.
Summary of Contents for PanelView Plus 2711P
