Allen-Bradley PanelView Plus 2711P, User Manual, Page: 37 / 170

Publication 2711P-UM001B-EN-P
Installation 2-11
400 - 600 Panel Installation
The PanelView Plus 400 and 600 terminals are installed in the same
manner using mounting levers. The number of levers used (4 or 6)
varies by terminal type. The mounting levers are shipped with each
terminal.
To install terminal in a panel:
1. Cut an opening in the panel using the panel cutout provided
with the terminal. Remove any sharp edges or burrs.
2. If Communication Module is ordered separately, attach module
to the base unit before panel installation. Refer to the
instructions shipped with module.
3. Make sure the terminal sealing gasket is properly positioned on
the terminal as shown. This gasket forms a compression type
seal. Do not use sealing compounds.
4. If using keypad legend strips on the 600 keypad terminals, we
recommend that you install the strips before installing the
terminal. Be careful not to pinch legend strip during installation.
5. Place the terminal in the panel cutout.
If installing terminal in existing 550 panel cutout, align terminal
with center of cutout for best gasket sealing.
ATTENTION
!
•
Disconnect all electrical power from the panel
before making the panel cutout.
•
Make sure the area around the panel cutout is
clear.
•
Do not allow metal cuttings to enter any
components already installed in the panel.
•
Failure to follow these instructions may result in
personal injury or damage to panel components.
Sealing Gasket
AB Drives