Allen-Bradley 2094-AL09, Installation Instructions Manual

Page: 27 / 60

Rockwell Automation Publication 2094-IN005H-EN-P - October 2012
Line Interface Module 27
Install the Line Interface
Module This procedure assumes that you have prepared your panel and understand how
to bond your system.
See the System Design for Control of Electrical Noise Reference Manual,
publication
GMC-RM001 , for information on high-frequency bonding and
reducing electrical noise.
Mount the Line Interface Module
Follow these steps to mount your line interface module to the panel.
1.
Layout the position for your module in the enclosure.
See Establishing Noise Zones beginning on page 6 for panel layout
recommendations. See Product Dimensions beginning on page 28 .
2.
Attach the line interface module to the cabinet.
The recommended mounting hardware is M6 metric (1/4 in.) bolts. Make
sure all fasteners are properly bonded to the subpanel.
3.
Tighten all mounting fasteners.
ATTENTION: To avoid hazard of electrical shock, mount your line interface module to
the panel before applying power. Once power is applied, connector terminals may have
voltage present even when not in use.
IMPORTANT
If you are using the 2094 mounting brackets and plan to mount your line interface
module over the AC line filter, you must install the line filter and brackets first. See the
2094 Mounting Brackets Installation Instructions, publication
2094-IN008 , for that
information.
Only the 2094-AL xx S and 2094-XL75S-C x line interface modules are compatible with
the 2094 mounting brackets. The 2094-BL xx S, 2094-AL09, and 2094-BL02 line
interface modules are not compatible.
IMPORTANT
To improve EMC performance, mount the line interface module on the same
panel as the drive and as close to the drive as possible.