Replacing the power-supply unit
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Procedure
WARNING: The cables and ports on the back of the power-supply unit are color-coded to indicate the different
power wattage. Ensure that you plug in the cable to the correct port. Failure to do so may result in damaging the
power-supply unit and/or system components.
1
Align and place the metal bracket on to the power-supply unit.
2 Replace the four screws (#6-32x6) that secure the metal bracket to the power-supply unit.
3 Press and hold the securing tab on the chassis and slide the power-supply unit into the chassis until it snaps into position.
94
Summary of Contents for Area-51 Threadripper Edition R7
