Replacing the front-bezel heat-sensor cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Procedure
1
Route the front-bezel heat-sensor cable through the bracket.
2 Align the tab on the front-bezel heat-sensor cable on the chassis.
3 Push the release tab on the front-bezel heat-sensor cable and press it into place.
4 Align and place the PCI fan holder from the chassis.
5 Replace the two screws (M3x5.25) that secure the PCI fan holder to the chassis.
6 Route the front-bezel heat sensor cable through the routing guides on the chassis.
7 Connect the front-bezel heat sensor cable to the system board.
82
Summary of Contents for Area-51 Threadripper Edition R7
