Replacing the hard drive
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
CAUTION: Hard drives are fragile. Exercise care when handling the hard drive.
Procedure
1
Align the screw holes on the hard-drive bracket with the screw holes on the hard drive (HDD1).
2 Replace the four screws (#6-32x3.6) that secure the hard drive to the hard-drive bracket.
3 Place the hard-drive assembly (HDD1) in the chassis.
4 Replace the screw (#6-32x6) that secures the hard-drive assembly (HDD1) to the chassis.
5 Connect the power cable and data cable to the hard drive (HDD1).
NOTE: Repeat step 2 to step 5 to replace any other hard drives (HDD2 and HDD3) installed in your computer.
36
Summary of Contents for Area-51 Threadripper Edition R7
