53
9.3.2 Customising Patrols
Patrols can be setup to move the PTZ to different key points and have it stay there for a
set duration before moving on to the next point. The key points are defined by presets
which can be set following the steps above in
Customising Presets
.
To set up and use PTZ patrols:
1.
Enter the PTZ Control interface, shown in figure 9.1 by clicking PTZ in the mouse
menu or the PTZ button on the front panel.
2.
Select the Patrol button to enter the Patrol Management menu, shown below.
3.
In the Patrol Management menu, you may:
Configure Patrol:
1.
Select a
Patrol Number
to set.
2.
Select valid presets (See
Customising Presets
) and click the Set button to enter the
Patrol configuration menu. A sequence should have at least 2 valid presets.
3.
Set the
Key Point No.
,
Duration
, and
Speed
(see below). The
Key Point No.
determines the order at which the PTZ will follow while cycling through the patrol. The
Duration
refers to the time span to stay at the corresponding key point. The
Speed
defines the rate at which the PTZ will move from one key point to the next.
Intelligent Security and Fire Ltd