AL-KO E.C.S12, Assembly And Operating Instructions Manual

Page: 27 / 240

3
Contents
1. Manufacturer’s Details
2. Introduction
3. Field of application
4. Safety Information
5. Scope of supply
6. As Installation
7. Operation
8. Emergency operation
9. Maintenance and care
10. Other Information
11. Fault Finding Plan
12. Warranty / Guarantee
1. Manufacturer’s Details:
Alois Kober GmbH • AL-KO Maschinenfabrik • D-89359 Kötz • Germany
Tel. ++49 (0)8221 970 • Fax ++49 (0)8221 97-390 •
email: fahrzeugtechnik@al-ko.de
2. Introduction
Read the operating instructions and act accordingly.
Keep the operating instructions for general use.
Obey the safety information and the warnings on the device.
Important safety component
Assembly only by an authorised garage
3. Field of application
The E.C.S. corner steady system enables the steadies on caravans and special trailers to be set,
parked and raised, electrically using a remote control.
4. Safety Information
Never allow the steadies to lower or raise unsupervised!
Careless or uncontrolled behaviour in the working area of the steadies could lead to consider-
able crushing injuries.
Switch the control off immediately after the function has been completed. Always remove the
key from the control, even if the caravan/trailer is temporarily steadied.
4.1 Before Operating the Steady System
•
On very uneven ground, place wheel chocks or wedges under the wheels.
•
Uncouple the trailer from the towing vehicle.
•
Check the condition of the base surface, use suitable shims if necessary!
•
No one is allowed in the caravan/trailer when the corner steady system is in operation.
Make sure everyone has departed from the Caravan!