AL-KO E.C.S12, Assembly And Operating Instructions Manual

Page: 39 / 240

15
Automatic “Switching Off”
As a rule the system that has been switched off, should be switched on again by operating the button.
Automatic switch off is activated in the following cases:
.. after operating the button “System on”
If no function is called up via the hand transmitter within a minute after switching on, then the sys-
tem switches off automatically.
.... after calling up an automatic function
The respective function is carried out after function call up of an automatic function via the remote
control. The control remains switched off for one minute after a steady is raised or lowered. The sys-
tem switches itself off after this time.
..... after calling up a manual function
After pushing a button on the hand transmitter for the last time, the control remains activated for a
period of
one minute . The system switches itself off after this time.
If however before this time has passed a function is called up via the remote control , then the time is
started again.
The LED “Power on” signals the operating state of the system
LED “Power light on” – system switched on
LED “Power light off” – system switched off
Automatic functions
Retracting the steadies automatically
Push the (short-duration pulse button) briefly.
All four steadies are automatically raised individually* (one after the other).
*(maximum of two)
Lowering the steadies automatically
Push the (short-duration pulse button) briefly.
All four steadies are automatically lowered individually* (one after the
other)
*(maximum of two)
When load is applied (ground contact) the control for the respective steady
automatically switches off .