AL-KO E.C.S12, Assembly And Operating Instructions Manual

Page: 40 / 240

16
Explanation of symbols for the following text (Manual functions):
Symbol „->“ means:
The buttons are to be pushed one after the other (not at the same time!)
The time between pushing the first and second button must not be longer than two seconds. If
the wait is longer, the function is not carried out.
Manual functions
Manually retracting the steady
button 1....4 -> button
Briefly push the respective number button (1, 2, 3, 4) then button .
The support selected previously is moved in so long as the button (con-
stant pulse button) is pushed.
The supports can only be raised individually in this manual function.
Manually lowering the steady
button
1....4 -> button
Briefly push the respective number button (1, 2, 3, 4) then button .
The steady previously selected is lowered as long as the button (constant
pulse button) is depressed.
The steadies can only be individually lowered in this manual function.
“Learning” Function
The remote control is coded. I.e. only your remote control can operate your E.C.S – control unit.
Should the remote control be faulty, stop functioning or be lost, then the E.C.S.-Control unit must
learn the code of the new remote control, in order to be able to carry out the functions.
Procedure as follows:
1. Insert the batteries in the battery compartment of the remote control.
Carry out a function test.
To do this, push any button on the hand transmitter.
The green LED in the hand transmitter must light up when the button is pressed.
2. Push the button on the control and hold it in this position until point 3.
After approx. 3 seconds the red LED “Power on” starts to flash every 0.5 seconds
+
+