HELO Plus H.264 Streaming and Recording Encoder v1.0 10 www.aja.com
Chapter 2 – Product at a Glance
Front Panel
Figure 2. HELO Plus Front Panel
Record
Button
Record LEDs Stream LEDs
USB LED
SD LED
Reset
Button
Audio Level Meters
Stream
Button
USB Storage
Port
SD Storage
Port
Power LED
Buttons
Once HELO Plus is powered up, configured, and properly connected, the two
buttons on the front panel are used to start and stop recording and streaming.
Record Button
Pressing the Record button initiates recording to the configured media types (SD
card, USB) and/or record path (Network Share), or stops all recordings in progress.
NOTE: Safeboot software recovery can be performed by pressing and holding the Record
button while powering up the HELO Plus. See
"HELO Plus Safeboot" on page 17
for more information.
Stream Button
Pressing the Stream button initiates the enabled streaming outputs, or stops any
streams in progress.
NOTE: The Record and Stream buttons can be linked using the HELO Plus web server
screen. When linked, pressing either button will start and stop both recording and
streaming.
Reset Button (Hardware)
A recessed hardware reset button is located next to the front USB port. This
button can be pressed using a paper clip, and has two functions.
Soft Reset -
Pressing and immediately releasing the button performs a soft reset.
This soft reset does not clear layouts, saved images, or network information.
The following information is retained.
