HELO Plus H.264 Streaming and Recording Encoder v1.0 17 www.aja.com
HELO Plus Streaming Quick Start
HELO Plus is shipped from the factory configured with the following basic
streaming settings:
• Input - (SDI, Video Source on HELO Plus web browser Config screen)
• Audio Input Source - (SDI, Audio Source on Config screen)
• Both Stream 1 and Stream 2 channels enabled using Encoder 1 as input.
• HLS Stream Type - (HLS on Stream 1/2 Output Screen)
• Streaming default format is Selected Input Video Geometry Full Frame Rate
10Mb HLS
HLS streaming requires no additional configuration. With default settings you can
simply connect a valid video/audio source to HELO Plus's SDI input and press the
Stream button on HELO Plus’s front panel.
HELO Plus Firmware Update
Visit the AJA website (
) to locate and download the latest
firmware. The following page provides support information and includes links to
locations where you can download updates:
https://www.aja.com/products/helo-plus#support
HELO Plus Safeboot
HELO Plus has a safety feature where an internal “safeboot” copy of minimal
system software is retained in the event the update process fails or the loaded
software becomes corrupted. The safeboot software provides minimal system
operation, intended only to restore the unit to a known configuration (the last
network configuration settings are retained) with which you can successfully
connect to the device over the network and download and reinstall fully
functional system software.
HELO Plus safeboot is initiated by holding in the front panel
Record
button while
powering up the unit, which launches the safeboot software version. When
running safeboot software a red Safeboot warning alarm is shown on the web UI.
With the safeboot software running, you will now be able to update your
HELO Plus to the latest version using the Web UI or eMini Setup.
