Airwell KXV Series, Engineering Manual

Page: 83 / 380

Engineering manual
83
1.6.5 Electric wiring

POWER SUPPLY WIRING
1. Unscrew and remove the service lid.
2. Connect the power supply wiring to the power supply terminal block.
3. When doing this, press the power supply wiring under the wire clip tightly.

Main-bus communication and R/C wiring
1. Unscrew and remove the service lid.
2. Connect the R/C wirings to R1-R2 terminal block and the main-bus wirings to F1-F2 terminal block.
3. Press the wirings under the wire clip tightly.

Tightening to torque for the terminal screws
Use the correct screwdriver for tightening the terminal screws. If the blade of screwdriver is too small, the head of the
screw might be damaged, and the screw will not be properly tightened. If the terminal screws are tightened too hard,
screws might be damage. Refer to the table below for the tightening torque of the terminal screws.
Terminal Size Tightening torque
Remote controller,Transmission wiring and forced off terminal block(4P) M3.5 0.8~1.0N · m
Power supply and Ground terminal block(3P) M4 1.2~1.5N
·
m
Chart 1-18