Airwell KXV Series, Engineering Manual

Page: 271 / 380

Engineering manual
271
 How to set I FEEL
Action Description Display
First dip
switch P2 set
to ON
Enter I-Feel setting
Group’s above line is ON if I-Feel is attached to
the group. Room Temperature is displayed
instead of SPT.
e.g. I-Feel is attached to Unit 2, 5, 6, 8, 9, 12
“>” or “<” is
pressed
Scroll up or scroll
down to select
group:
1 – 2 – 3 – … – 15 – 16 –
ALL
Selected Group number is blinking, and the
selected group is shown in the front.
Press “OK”
Attach / Un-attach I-Feel
function to the selected
group
Above line is ON if attached.
Above line is OFF if un-attached
e.g. un-attach I-Feel function to group 5, 8
DIP switch
P2 set to
OFF
Exit and save I-Feel
settings
Return to normal display before enter I-feel
setting.
2.4.3 Master/Slave LWC setting
(1) When two local wired controllers are installed in one R/C wiring, one should be set as master, the other should
be slave, it is set by one dip switch P3 (Master/Slave) which hidden in the back of LWC. Control system will
distinguish the setting after power on, or master/salve conflict fault will be warned.
(2) When only one LWC is installed in one R/C wiring, the LWC should be set as master, or the group will work
unusual.
(3) When DIP switch P3 (Master/salve) is in OFF position, LWC is master; When DIP switch P3 (Master/ slave) is
in ON position, LWC is slave; Default setting is OFF.
(4) Choose one LWC as slave, and change dip switch P3 to ON position. Normally, from the angle of using, no any
special difference between master and slave, only need considering about I-feel setting when choose which one
to be master.