Airwell DFO 5 - 9 - 17, Installation And Operation Manual

Page: 30 / 45

8 - CONTROL
8.2
UNIT STATUS
During the operation is possible to visualize the unit status by the values obtained from sensors and from the main unit
operating parameters.
N. Description U.M.
1 Current set point °C
2 Operative T return °C
3 Return Temperature I/O °C
4 Return Temperature from sensor thermostat °C
5 Input water Temperature source I/O °C
6 Output water Temperature source I/O °C
7 Exchanger Temperature treatment coil utility I/O °C
9 Electronic thermostatic return Temperature °C
10 High/low Pressure bar
11 Electronic thermostatic return pressure bar
12 Thermal load to the source °C
13 Read overheating °C
14 Current overheating setPoint °C
15 Thermostatic valve position %
16 Satured evaporating T calculated on °C
17 Overheating Delta for Mop °C
18 Modulating fan output Out %
19 Modulating compressor output Out %
20 Source water valve output Out %
21 Digital input status bitmap-byte
22 Digital output status bitmap-byte
23 Compressor 1 starts bitmap-byte
24 Compressor 1 hours bitmap-byte
25 Unit hours in ON bitmap-byte
26 Topographic map of the nodes connected in the mininet bitmap-byte