12 - DECOMMISSIONING
THE UNIT MUST ALWAYS BE SENT TO AUTHORISED
CENTRES FOR DISMANTLING AND DISPOSAL.
When dismantling the unit, the fan, the motor and the coil, if
operating, may be recovered by the specialist centres for
reuse.
All the materials must be recovered or disposed of in
compliance with the corresponding national standards in
force.
For further information on the decommissioning of the unit,
contact the manufacturer.
12.1
DISCONNECTION
Only authorised personnel must disconnect the unit.
•
Avoid leak or spills into the environment.
•
Before disconnecting the unit, the following must be
recovered, if present:
- refrigerant gas
- Anti-freeze solutions in the hydraulic circuits
•
When awaiting dismantling and disposal, the unit can
also be stored outdoors, as bad weather and rapid
changes in temperature will not cause damage to the
environment, if the unit's electric, cooling and hydraulic
circuits are integral and closed.
The manufacturer is registered on the EEE National Register,
in compliance with implementation of Directive 2012/19/EU
and relevant national regulations on waste electrical and
electronic equipment.
This Directive requires electrical and electronic equipment to
be disposed of properly.
Equipment bearing the crossed-out wheelie bin mark must be
disposed of separately at the end of its life cycle to prevent
damage to human health and to the environment.
Electrical and electronic equipment must be disposed of
together with all of its parts.
To dispose of “household” electrical and electronic equipment,
the manufacturer recommends you contact an authorised
dealer or an authorised ecological area.
“Professional” electrical and electronic equipment must be
disposed of by authorised personnel through established
waste disposal authorities around the country.
In this regard, here is the definition of household WEEE and
professional WEEE:
WEEE from private households: WEEE originating from
private households and WEEE which comes from commercial,
industrial, institutional and other sources which, because of its
nature and quantity, is similar to that from private households.
Subject to the nature and quantity, where the waste from EEE
12.3
CE WEEE DIRECTIVE
12.2
DISMANTLING AND DISPOSAL
was likely to have been by both a private household and users
of other than private households, it will be classed as private
household WEEE;
Professional WEEE: all WEEE which comes from users other
than private households.
This equipment may contain:
•
refrigerant gas, the entire contents of which must be
recovered in suitable containers by specialised personnel
with the necessary qualifications;
•
lubrication oil contained in compressors and in the cooling
circuit to be collected;
•
mixtures with antifreeze in the water circuit, the contents
of which are to be collected;
•
mechanical and electrical parts to be separated and
disposed of as authorised.
When machine components to be replaced for maintenance
purposes are removed or when the entire unit reaches the
end of its life and needs to be removed from the installation,
waste should be separated by its nature and disposed of by
authorised personnel at existing collection centres.
directly by the distributor.
Summary of Contents for DFO 5 - 9 - 17
Page 17: ...6 ELECTRICAL CONNECTIONS 6 3 ELECTRIC PANEL SIZES 5 9 ELECTRIC PANEL SIZES 17 X1 X1 A B A B C2...
Page 24: ...6 ELECTRICAL CONNECTIONS...
Page 43: ...NOTES...
Page 44: ...NOTES...
