AIR2G2 AIR2G2-336, Owner'S/Operator'S Manual

Page: 25 / 63

26
WARNING! KEEP HANDS AND FEET AWAY FROM THE PADS. WHEN FINISHED USING THE MACHINE,
ALWAYS ATTACH THE CHAINS BACK TO THE PIN ON EITHER SIDE OF THE FRAME (I.E. IN A HOME OR
STORED POSTION [UP]).
6) The handle bars always rest in the neutral position. In this position, the brake is automatically set.
7) Standing in the operator’s position, PUSH the handle bars to release the brake and engage a REVERSE motion.
Standing in the operator’s position, PULL the handle bars to release the brake and engage in a FORWARD
motion. NEVER FOR ANY REASON, OVER-EXTEND OR APPLY PRESSURE TO THE HANDLE BARS
WHILE MOVING THE MACHINE WITH OR WITHOUT THE ENGINE RUNNING. DAMAGE CAN OCCUR TO
THE CABLE OR THE CABLE CONNECTIONS. WALK THE MACHINE ONLY IN THE WALKING RPM AS
SHOWN ON PAGE 23
8) The trigger buttons, located at the ends of both the right and left handle bars, are depressed simultaneously to
start the aeration process.
9) Standing in the operator’s position behind the handle bars, flip the toggle switch on the right side of the dash to
the UP/ON position. The screen will read “SELECT MODE” 1=AUTO / 2=MANUAL (SEE FUNCTION KEYS
FOR THE PLC ON THE FOLLOWING PAGE). Press 6 and hold. The screen will read “RESET TO FACTORY”,
1=YES / 3=NO. Press 1=YES. FACTORY DEFAULT SETTING HAVE BEEN RESET.
10) Press 1=AUTO. PLC will read TRIGGER TO START. Once in position to begin the aeration process, slide the
throttle lever completely to the left. Trigger buttons at each end of the handle bars must be depressed
simultaneously for the aeration process to begin.
11) The beam will lower the three (3) pressure pads to the surface.
12) The cross member will have heim joints that lock into place, putting a partial amount of the machine weight on
these pads. The three (3) cylinders will then insert the three (3) probes into the ground with the pressure from
gauge 1. NOTE: checking the actual depth of the hole is recommended before starting the job to make
sure the correct length probes are in use.
13) Fracturing and movement maybe seen on the surface after this has been done. When each injection is timed
out, the cylinder rod will bring the probes out of the ground “QUICKLY”.
14) Once the probes are out of the ground and the cylinder rods are all the way up, the beam will then lift the three
(3) pads from the surface. The operator may now move the machine 3-4 feet (.9144-1.2192 m) and repeat this