AIR2G2 AIR2G2-336, Owner'S/Operator'S Manual, Page: 24 / 63

25
WARNING! DO NOT TOUCH OR STAND NEAR THE CYLINDER RODS DURING OPERATION.
4) If the engine has not been started for more than 8 hours: Before turning the key to start, turn key to the
on position, allow the electronic fuel pump to fill the fuel filter, now turn to start engine. To set engine
Speed/RPM for safely moving machine from location to location, slide throttle control ¼ ways to the UP
position. See PICTURE below.
NOTE: Do not tow. The machine must be walked or trailered to the desired location to begin the aeration process.
WARNING! DO NOT RIDE THIS MACHINE. TO AVOID ACCIDENTS, A QUALIFIED OPERATOR MUST BE
AWARE OF THEIR SURROUNDINGS AND REMEMBER THAT IT IS YOUR RESPONSIBILITY TO THINK AND
OPERATE SAFELY.
NOTE:
Wear proper clothing, footwear, and eye protection. Ear protection is required.
5) After the motor is running: Above the beam (see picture) release the chain from the side – one on the left
and one on the right side. These chains are stored by inserting the chain onto a
pin located on the beam.
This will now allow the beam to move in a downward motion, setting the pads on the surface with pressure.
Now, move the throttle to FULL operating position (see pic BELOW).
IDLE RPM WALKING RPM OPERATING RPM