AIR2G2 AIR2G2-336, Owner'S/Operator'S Manual

Page: 32 / 63

3 3
MAINTENANCE AND STORAGE
NOTE:
Be sure the beam and all 3 cylinders are secured in the “Home” / stored (UP) position.
a) With the PLC in the AUTO/MANUAL mode Press and release 8 (PURGE) and air will be released through
the probes. This can be done with or without the motor running. Doing this for 5-7 seconds will help to clean
any dirt from the probes. Press 8 again to stop (PURGE).
b) ADVISED AIR PRESSURE RELEASE – Open manual drain on the right under-side of air tank allows for
condensation to be drained from the air tank. Do this off of the turf surface .
c)
ADVISED AIR PRESSURE RELEASE
- Slightly loosen the outlet on the air water separator (SEE PIC) and
let air pressure escape while cleaning out any condensation. Do this until all air is completely released from
the system, and then tighten release knob
.
•
Wait for all movement to stop on the machine before adjusting, cleaning or repairing. The beam must be in the
upward and secured position; the brake will be engaged with the handle bars in the neutral position, stop the
engine, and put the PLC in the OFF position.
• Clean the machine from all grass. Clean all debris from the probes, mufflers and engine to help prevent fires.
DO NOT PRESSURE WASH. Use low pressure water. If there is any oil or gas spillage, remove and clean
the area. You may use industrial quick-disconnect to attach an air hose/nozzle to blow off dirt and debris.
•
Let the engine cool down before storing. Do not store near flames or anything that may be flammable.
•
Do not store fuel near flames or drain fuel when indoors.
• The machine must be parked on a level ground. Do not allow untrained personnel to service the machine.
•
Use built in jack stands or safety latches to support components of the machine if needed.
•
Carefully release pressure from machine components with stored air pressure (see maintenance schedule).