VELTRON II
Air Monitor Corporation
116-011-98.P65 (8/30/10)
VELTRON II - IO&M Manual
5.1 – INTRODUCTION
The VELTRON II has been configured and calibrated at the Factory to customer specified parameters which are
recorded on the VELTRON II Factory Set-Up Information Sheet, included with the unit. Review this information and
verify that the VELTRON II setup is correct for your applications. If any problems or discrepancies are detected, contact
Air Monitor's Customer Service Department at 1-800-AIRFLOW prior to proceeding.
5.2 – START-UP
1.
After Installation has been verified in accordance with Section 4, turn power switch located at the lower front side to
the ON position (see Figure 4.1).
2.
Display will briefly indicate:
VELTRON II
with the
progressing from left to right.
Followed by:
Performing Auto-Zero
with the progressing from left to right.
After approximately 10 seconds, the unit will return to
Normal
display mode, and green LED indicating "CPU
Activated" will flash rapidly (4 times per second). This is
Normal
operation mode and no further user interface is
required. If, however, user would like to verify configuration or change user selectable parameters, continue to
Section 5.4 entitled "CONFIGURATION".
11
SECTION 5 – OPERATION
5 – OPERATION
Summary of Contents for VELTRON II
Page 2: ......
