AiP ABL-005IR, Manual

Page: 43 / 72

SWIR Line Camera Series User’s Manual
(OM150000013H-EN)
－ 43 －
4-14-1
Line 0,1,2 (CC1~4)
Line0 and Line1 are as two-way signal accessible in GPIO
circuit. Line2 is accessible in GPI cicuit only.
Please refer to the section 3-3 GPIO Connection for the
details.
In case of CameraLink version camera, additional input
signal can be assigned with CC1~CC4.
※
CC1 ～ CC4 is for input only.
Following is command list to change source of Line* signal.
NOTE
ABL-010IR-CL is not supported.
ABL-010IR-GE is supporting GPI only.
command param1 Description
CL line-format
0 No Connect
4 EIA-422 Level ※
7 EIA-422 Level
without Input terminating
resitances
GV LineFormat
NoConnect No Connect
TTL VHI : +2.0V ～ +5.0V
VIL : +0V ～ +0.8V
RS422 EIA-422 Level ※
RS422
without
terminal
EIA-422 Level
without Input terminating
resitances
※
In case selected EIA-422 level and set LineMode to Input,
it is connected to On Chip Termination automatically.
Following is command to change input direction of Line*
signal.
command param1 Description
CL line-mode
0 Input
1 Output
GV LineMode
Input Input
Output Output
Followng is command to acquire current signal’s level.
command param1 Description
CL line-status
0 Negate
1 Assert
GV LineStatus
Off Negate
On Assert
Following is command to reverse the level of Negate or
Assert.
command param1 Description
CL line-inverter
0 Non inverted
1 Inverted
GV LineInverter
Off Non inverted
On Inverted
4-14-2
Line 0,1,3~6 Output
Line 0,1,3~6 can be connected to the signal output from
Acquisition Control or the signal from
「
UserOutput
」
.
NOTE
ABL-010IR-CL is not supported.
User can select the signal to connect to by following
command.
command param1 Description
CL line-source
0 AcquisitionTriggerWait
4 AcquisitionActive
14 ExposureActive
33 UserOutput0
35 UserOutput1
255 OFF
GV LineSource
Off
AcquisitionTriggerWait
AcquisitionActive
ExposureActive
UserOutput0
UserOutput1
UserOutput2
※ 1
UserOutput3
※ 1
UserOutput4
※ 1
UserOutput5
※ 1
UserOutput6
※ 1
NOTE
※
1 ABL-010IR-GE is supported only.
※
In case TriggerMode of Acquisition_** is set to 1, Acquisition
Trigger Wait is asserted until trigger is input.
To
Line Inverter
Acquisition Trigger Wait
※
Acquisition Active
Exposure Active
User Output0
User Output1
User Output2
OFF
Line Source
SEL
assert
negate