AiP ABL-005IR, Manual

Page: 18 / 72

SWIR Line Camera Series User’s Manual
(OM150000013H-EN)
－ 18 －
3. Connection
3-1
GigE Setting
3-1-1
Network Setting
In order to connect the camera to the network, address of
the following items must be configured with the proper
value.
･
IP Address
･
Subnet Mask
･
Default Gateway
Network address configuration can be done by one of the
following three methods.
･
Use of Persistent IP
; User-specified IP
･
Use of DHCP
; DHCP server automatically assigns IP
･
Use of Link Local Address
（
LLA
）
; Camera automaticallyassigns IP
Use of Persistent IP
In case IP address which will be used for the camera is
already fixed, Persistent IP can be used, and subnet mask
and default gateway setting should also be required.
Use of DHCP
The camera can be configured the IP address with DHCP
server. In case of DHCP mode, subnet mask and default
gateway configuration can also be done automatically.
Use of LLA
In case of not using Persistent IP and IP address cannot
be configured by DHCP server, the user can configure IP
by LLA mode as well. In this mode, IP is assigned as
169.254.XXX.ZZZ, and XXX and ZZZ are automatically
assigned.
In addition to the above items, following network setting
can be set.
・
Packet Size
・ Packet Delay
Packet Size
NOTE
It is possible to set the size per packet when the image
data is transmitted. In order to run the camera properly, the
packet size should be the same or less than MTU of the
network device.
Packet Delay
Packet delay is the time delay between when a packet of
data goes from one place to another, and the user can set
this value. If increasing packet delay, data bandwidth rate
can be reduced, and it may result in reducing frame rate
as well.
NOTE
Persistent IP address can be set arbitrarily. However,
depending on the host PC, it may not be able to detect the
camera. In this case, it requires to reset Persistent IP by
the tool forcing IP address.
Network Setting Reset
The network settings can be reset to the factory default
settings by turning DIP switch 2 ON and supplying power
on. After restarting the camera, be sure to set the DIP
switch 2 OFF.
Persistent IP
Persistent SubnetMask
Persistent Gateway
DHCP = Off
Persistent IP = Off
LLA = On