Agilent Technologies Magnis Dx NGS Prep System, User Manual

Page: 34 / 96

Magnis/Magnis Dx NGS Prep System
User Guide
34
4 Operating the System
Running Protocols 35
Prepare the instrument for running a protocol 35
Prepare the reagents and plasticware 35
Set up and initiate the protocol run 36
Collect final library samples and clean up the system 37
Running and Viewing Diagnostic Tests 38
Perform instrument diagnostic tests 38
View reports for diagnostic tests and instrument health checks 39
Decontaminating with UV Light 41
Run a decontamination “quick cycle” 41
Run a UV decontamination “extended cycle” 42
Running Auto-Teaching and Teach-Point Verification 43
Run auto-teaching 43
Include teach-point verification in the IHC 44
Installing Updates 45
Install protocol updates 45
Install firmware updates 47
This chapter contains instructions on operating the Magnis/Magnis Dx NGS Prep System,
including running protocols, performing diagnostic tests, decontaminating the instrument deck,
running auto-teaching, and installing protocol and software updates.
NOTE
To avoid introducing contaminants, always wear gloves when operating the
Magnis/Magnis Dx NGS Prep System.
CAUTION
Keep the humidity levels in the laboratory between 30% and 70%
non-condensing. Operating the system in humidity levels outside of this range
can impact performance.