Agilent Technologies M1205A V24, Service Manual

Page: 269 / 358

$JLOHQW0$996HULHV6HUYLFH*XLGH
)URQW+RXVLQJ$VVHPEO\9&9& 9&79&7
F
r
on
t H
o
u
s
in
g
A
ssem
b
ly
V
2
4C
/V
26
C
& V
2
4C
T/
V
2
6
C
T
5HPRYLQJWKH)ODW3DQHO%DFNOLJKW7XEH
:LWKRXWIXOO\GLVDVVHPEOLQJWKH)URQW+RXVLQJ
Remove the Front Housing Assembly.
Remove the Flat Panel Display Assembly.
Turn the Flat Panel Display Assembly over and lay on a clean flat surface (Display side
up) with the 3-wire backlight cable connector side facing you.
Remove the two screws (securing the flat panel to the flat panel bracket) at the end nearer
to you.
/RRVHQ
the two screws at the other end.
Carefully remove the 3-wire backlight cable from the Flat Panel Adapter Board.
Gently lift the near end of the Flat Panel.
Using your fingernail or a small flat-bladed screwdriver, press the tiny black clip holding
the backlight in its channel.
By gently tugging on the 3-wire connector, slide the backlight out from its channel.
,I)URQW+RXVLQJLVIXOO\GLVDVVHPEOHG
Carefully place the Flat Panel with display side down on a clean flat surface.
Using your fingernail or a small flat-bladed screwdriver, press the tiny black clip holding
the backlight in its channel.
By gently tugging on the 3-wire connector, slide the backlight out from its channel.
Do not touch fluorescent tube when removing or installing the backlight as oil from
fingerprints will shorten the operating life of the tube.
Now continue the disassembly procedure on page 9-18
127(