Agilent Technologies M1205A V24, Service Manual

Page: 187 / 358

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HSDLULQJWKH$JLOHQW0RGHO9
R
e
p
a
ir
in
g
th
e
Ag
il
e
n
t
M
o
d
e
l V
2
4
5HPRYLQJWKH)URQW+RXVLQJ$VVHPEO\
Remove 4 screws from the rear of the Front Housing Assembly. Separate Front Housing
Assembly from Rear Housing and lay it down on a flat surface.
Disconnect the Keypad cable from the System Board.
Disconnect the Flat Panel data cable from the Flat Panel Adapter Board.
Disconnect the contrast knob connector from the Flat Panel Adapter Board.
NOTE: If your Agilent M1205A uses the SDN Daughter Card for SDN connectivity, some
hardware will be different than what is shown in the illustrations in this chapter. Refer to
Appendix A for information on the Agilent M1205A with the SDN daughter card.
Front Housing Assembly
Rear Housing