Agilent Technologies E4419B, User Manual

Page: 45 / 205

Power Meter Operation 2
E4419B Power Meter User’s Guide 23
Introduction
This chapter describes the parameters which configure the power meter to
make measurements and help you determine settings to optimize
performance. This chapter contains the following sections:
•
“Battery Operation (Option 001)” on page 25.
•
“Zeroing and Calibrating the Power Meter” on page 30.
•
“Calibrating the Power Meter” on page 31.
•
“Making Measurements with the Agilent E-Series Power sensors and N8480
Series Power Sensors (excluding Option CFT)”
on page 41.
•
“Making Measurements with the Agilent 8480 Series and N8480 Series
Power Sensors with Option CFT”
on page 43.
•
“Making Measurements using Sensor Calibration Tables” on page 46.
•
“Making Measurements using Frequency Dependent Offset Tables” on
page 56
•
“Setting the Units of Measurement” on page 62.
•
“Selecting Units of Measurement from the Softkeys” on page 63.
•
“Making Relative Measurements” on page 64.
•
“Setting the Resolution” on page 65.
•
“Setting Offsets” on page 66.
•
“Setting Averaging” on page 68.
•
“Measuring Pulsed Signals” on page 71.
•
“Setting Measurement Limits” on page 73.
•
“Channel Measurements” on page 79.
•
“Making Difference Measurements” on page 80.
•
“Making Ratio Measurements” on page 81.
•
“Selecting a Digital or Analog Display” on page 82.
•
“Setting the Range” on page 85.
•
“Configuring the Remote Interface” on page 86.
•
“Recorder Outputs” on page 92.
•
“Saving and Recalling Power Meter Configurations” on page 94.
•
“How Measurements are Calculated” on page 96