Agilent Technologies 929-0022, Instruction Manual

Page: 21 / 36

INSTRUCTION FOR USE
16 87-900-077-01(D)
Detailed information about the operating modes are contained in
the appendix “Technical Information”.
Sublimation Controller Switching ON
To switch ON the Sublimation Controller switch the power switch
located on the rear panel to the “I” position.
To start the sublimation, push the “SUBLIMATION” key located
on the front panel and the relevant green LED will light.
NOTE
If the “SUBLIMATION” key is not set in ON position the
sublimation will not starts and the unit will wait for a parameters
setting.
Sublimation Controller Switching OFF
To switch OFF the Sublimation Controller , proceed as follows:
−
set the “SUBLIMATION” key in OFF position (green LED
extinguished)
−
switch the power switch located on the rear panel to the “O”
position.
MAINTENANCE
The Sublimation Controller does not require any maintenance.
Any work performed on the pump must be carried out by
authorized personnel.
,
WARNING!
Before carrying out any work on the controller, disconnect it from
the supply.
In the case of breakdown, contact your local Varian service
center who can supply a replacement controller.
NOTE
Before returning the pump for repairs, or replacement with a
reconditioned unit, the "Health and Safety" sheet attached to this
instruction manual must be filled-in and sent to the local sales
office. A copy of the sheet must also be inserted in the pump
package before shipping.
If a controller is to be scrapped, it must be disposed of in
accordance with the specific national standards.
DISPOSAL
Meaning of the "WEEE" logo found in labels
The following symbol is applied in accordance with the EC
WEEE (Waste Electrical and Electronic Equipment) Directive.
This symbol (
valid only in countries of the European
Community ) indicates that the product it applies to must NOT be
disposed of together with ordinary domestic or industrial waste
but must be sent to a differentiated waste collection system.
The end user is therefore invited to contact the supplier of the
device, whether the Parent Company or a retailer, to initiate the
collection and disposal process after checking the contractual
terms and conditions of sale.
ERROR MESSAGES
For a certain type of failure, the controller will self-diagnose the error and the messages described in the following table will be displayed.
MESSAGE DESCRIPTION REPAIR ACTION
POWER AC FAIL Anomalous operation relevant to the power
supply due to an incorrect power supply
voltage. Switch OFF the unit then check the power
supply and the correct setting of voltage input
values (110 - 120 Vac, 60 Hz o 220 - 240 Vac,
50 Hz).
HEATER DEFECTIVE Heater filament interruption during a pumping
cycle with the Mini Ti-Ball. Replace the Mini Ti-Ball.
FILAMENT X
DEFECTIVE
Filament X (where X can be 1, 2 or 3)
interruption during a sublimation with the TSP.
If the “TSP RECOVER” parameter is set in
“AUTOMATIC” the software restart the normal
operation, selecting a successive cartridge
filament.
If the “TSP RECOVER” parameter is set in
“MANUAL” the sublimation will turn off. If the “TSP RECOVER” parameter is set in
“AUTOMATIC”, the software selects
automatically one of the remaining filament, and
the relevant LED will be ON.
If the “TSP RECOVER” parameter is set in
“MANUAL” the user must manually restart the
sublimation procedure.
CARTRIDGE
DEFECTIVE XXX All TSP filament are interrupted and the
sublimation is turned off. Replace the cartridge.
FAULT:
OVERTEMPERATURE Transformer overload occurs and the pumping
cycle is stopped. Eliminates the cause of the overload on the
transformer.
EXTERNAL
INTERLOCK The interlock on pin 3 of the I/O connector is
not connected. Connect the interlock.